Select Menu > Ctrl. panel > Settings and Phone.

Select from the following:

Call - Define general call settings.

Call forwarding - Define your call forwarding settings. See Call forward.

Call restriction - Define your call restricting settings. See Call restrictions.

Network - Adjust the network settings.

Call settings

Select Menu > Ctrl. panel > Settings and Phone > Call.

Select from the following:

Send my caller ID - Display your phone number to the person you are calling.

Call waiting - Set the device to notify you of incoming calls while you are in a call (network service).

Decline call with msg. - Send a text message when you reject a call, informing the caller why you could not answer the call.

Message text - Write the standard text message that is sent when you reject a call.

Own video in recvd. call - Allow or deny video sending during a video call from your device.

Image in video call - If video is not sent during a video call, you can select a still image to be displayed instead.

Automatic redial - Set your device to make a maximum of 10 attempts to connect the call after an unsuccessful call attempt. To stop automatic redialing, press the end key.

Show call duration - Display the length of a call during a call.

Summary after call - Display the length of a call after a call.

1-touch dialing - Activate 1-touch dialing.

Anykey answer - Activate anykey answer.

Contact search - Activate contact search in the home screen.

Network settings

Select Menu > Ctrl. panel > Settings and Phone > Network.

To select the network mode, select Network mode and Dual mode, UMTS, or GSM. In dual mode, the device switches automatically between networks.

Tip: Selecting UMTS enables faster data transfer, but may increase the demand on battery power and reduce the battery life. In regions close to both GSM and UMTS networks, selecting Dual mode may cause constant jumping between the two networks, which also increases the demand on battery power.

To select the operator, select Operator selection and Manual to select from available networks, or Automatic to set the device to select the network automatically.

To set the device to indicate when it is used in a microcellular network (MCN), select Cell info display > On.