Using the Uninterruptible Power Supply (UPS) service

After you have purchased an Uninterruptible Power Supply (UPS) for your computer, you can use the UPS service to set options for its operation using Power Options in Control Panel. The UPS tab in Power Options enables you to control how the UPS service works on your computer. The UPS settings available depend on the specific UPS hardware installed on your system. The settings can include options such as:

The serial port where the UPS device is connected.

The conditions that trigger the UPS device to send a signal, such as a utility power failure, low battery power, and remote shutdown by the UPS device.

The time intervals for maintaining battery power, recharging the battery, and sending warning messages after power failure.

Install an Uninterruptible Power Supply (UPS) device

Configure a simple-signaling Uninterruptible Power Supply (UPS) device

Remove an Uninterruptible Power Supply (UPS) device

Configure an Uninterruptible Power Supply (UPS) device

Test your Uninterruptible Power Supply (UPS) service configuration

Computer Management overview

Using Computer Management



© 2016 Microsoft Corporation. All rights reserved. Contact Us |Terms of Use |Trademarks |Privacy & Cookies