ArduinoLab allows you to control the digital inputs and outputs of Arduino 1 Rev.3 through the USB port. It Allows Arduino to control 6 users through relay and acquire the status of 6 analog and 6 digital inputs. The digital inputs and relay outputs are equipped with an LED that signals its status. The board is powered directly from the Arduino module, which provides 5 volts derived from its regulator between 5V and GND contacts. The mini-relay Shield operate at 12 volts, so that the relays are working properly you have to power the Arduino module with an external power supply can provide this voltage. The card can be used in many applications and in many ways.
What’s new in this version
R.1.2.5 in this version: saving the VID and PID addresses Usage Notes: To use this app you must 1) be loaded via the Arduino IDE sketch StandardFirmata 2) Arduino Connect the USB port of your PC and download the sketch 3) configure the USB port by reading the value of VID and PID then copying them in two boxes and confirm with the OK button USB ID CAUTION !!! Perform these tasks before using the app.
- Request USB port and load the firmware in StandardFirmata Arduino
Published byErreBi Lab
Developed byErreBi Lab
Approximate size18.82 MB
Age ratingFor ages 3 and over
CategoryDeveloper tools > Design tools
This app canBluetooth device
Access your Internet connection